|
| |
ST-3003 Series Ethernet Andon Display Resources
|
ST-3003-245 3-point Ethernet Andon |
The Andon has two AC outputs
that can optionally be used to control other devices. The AC outputs are
controlled by optically isolated relays with a zero crossing circuit. The
relays only turn off /on when the AC cycle is crossing zero volts which can
dramatically extend the life span of some devices such as incandescent light
bulbs. If the Andon is powered from 120VAC power, then the outputs supply
120VAC.If the Andon is powered from 240VAC power, then the outputs supply
240VAC. In either case the peak power draw must not exceed 60W. |
Other Details:
| A standard RJ45 100bT
Ethernet connection is provided on the right side of the Andon. When the
unit is turned on, it will contact the DHCP server on your network to get an
IP address. In order to keep the IP address stable, your network
administrator will need the Andon MAC address, which is printed on the
bottom of the unit, to setup an IP address reservation in the DHCP server.
If you wish to access the Andon using a descriptive name instead of an IP
address, your network administrator will also need to add an entry to your
DNS database. |
|
